Merlin Powerlift Installationsanleitung PDF herunterladen (Seite 32)

Disarm the system when immobilized

Use one of the following methods to turn off auto-immobilization

Turn ignition on and press the button of the transmitter.

Arm the alarm and then disarm the alarm.

Turn the ignition on and enter the system Valet/PIN code.

troubleshooting and system testing

Checking arm/disarm.

Use the button on both remote controls to arm and disarm the alarm.

Use the button on the 3-button remote to silently arm and disarm the

alarm.

Repeat both tests at required distance to test range.

Testing disarming without a remote

1. Turn the ignition On.

2. Enter the preset PIN code as described in the

Programming Instructions

section.

3. Then press the button once to disarm without a remote.

Testing the tilt sensor.

Arm the alarm with the motorcycle resting on its side stand. Wait at least 10 seconds.

Tilt the motorcycle upwards as though you were going to push it away. The

alarm should trigger.

Adjust sensitivity as necessary.

Testing Ignition Trigger.

Arm alarm

Turn ignition on, alarm should trigger.

Disarm alarm.

Testing the protection switch.

Arm the alarm system.

Attempt to remove the panel required to access the alarm control unit.

The alarm should trigger. Adjust or reshape protection switch lever if required.

Testing the N/O–N/C programmable input.

Arm the alarm.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37

Keine Kommentare

Merlin Powerlift Installationsanleitung Seite 32