Merlin Powerlift Installationsanleitung PDF herunterladen (Seite 22)

If the feature has more than two settings, continue pressing the arm/disarm but-

ton on the transmitter to toggle through the settings (e.g. if the feature has 1

through 5 settings, the system will chirp 1 through 5 times for each setting select-

ed). If you continue to press and release the transmitter the feature setting will

wrap back around to the first setting again. (e.g. if the feature has 3 settings you

will hear, 1 chirp, 2, chirps, 3 chirps, 1 chirp, 2 chirps, etc).

To advance to another feature in the same column, press the same number

of times as the desired feature within 60 seconds; to change a feature in a

different column begin at step 5 by entering the column number first and then

the feature select in step 6.

NNOOTTEE::

Refer to the

Feature Descriptions

sections of this guide for important notes and

descriptions of the system features and programming.

8. Grid Jump - To change a feature in a

different

feature grid - Press and hold the

button for 10 seconds and you will jump from one grid to another. (e.g. You

are in the user programming grid and would like to jump to the installer grid.

Press and hold for 10 seconds, you will hear 3 chirps indicating installer

grid entry. Now program the features by entering the columns and rows as

described previously.) 3 chirps are always heard when entering installer pro-

gramming grid and 1 chirp when entering user programming grid.

9. Exit programming - To exit programming mode turn the ignition off or wait 60

seconds without pressing the Valet switch. The siren will chirp three times to indi-

cate programming mode has been exited.

NNOOTTEE::

After you change a feature setting, the feature counter is reset to zero. Hence,

to change another feature in the same column you must press the button the same

number of times as indicated in the chart below.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 36 37

Keine Kommentare

Merlin Powerlift Installationsanleitung Seite 22