Merlin Powerlift Bedienungsanleitung PDF herunterladen (Seite 3)

EDR4 1169 G 10/03

Contents

Safety Instructions 2 & 3

Site requirements 4

Preparing the opener 5

Installing the opener 7

Setting door travel limits 11

Setting the force sensitivity 12

Setting up wireless controls 13

Adding the Merlin M102

non-contact beam sensor 14

Improving door security 14

Manual operation 14

Operating from a remote 15

Troubleshooting 15

Optional accessories 17

Specifications 17

Warranty 18

Merlin Service Centres 20

Important safety instructions for

installation

WARNING Incorrect installation can lead to severe injury. Follow all installation

instructions.

Garage doors are under great spring tension. Do not attempt to adjust spring tension. Do not

loosen any brackets under spring tension. Do not remove springs from the door. Merlin Ga-

rage Openers Limited do not accept responsibility for damage or injury resulting from install-

ing this opener. If you have any concerns please consider having the opener installed by an

Authorised Merlin Installer.

To avoid difficulty during installation, do not connect the opener to the mains or run the door

opener until instructed to do so.

Do not use force sensitivity adjustments to compensate for a binding or sticking garage door.

Excessive force may damage the garage door.

Before installing the drive remove all unnecessary ropes or chains and disable any equip-

ment, such as locks, that is not needed for powered operation.

Before installing the drive check that the door is in good mechanical condition and that it is

correctly balanced. Check that it opens and closes

properly.

Install the actuating member for the manual re-

lease (red handle on a rope) such that it rests at a

height of less than 1.8 m.

Install any fixed control, wired or wireless, within

sight of the door but away from moving parts and

at a height of more than 1.5 m.

Install the drive such that all moving parts (except

the door and the manual release) are at a height

of more than 1.8 m.

Permanently attach the label warning against en-

trapment in a prominent place, or near any fixed

control.

Permanently fix the label concerning the manual

release adjacent to its actuating member (thread

the cord through the holes in the manual release

warning card).

After installation, ensure that the mechanism is

properly adjusted and that the drive reverses when

the door contacts a 40 mm high object placed on

the floor.

The appliance is not intended for use by young

children or infirm persons without supervision.

If the supply cord is damaged, it must be replaced

by the manufacturer or its service agent or a simi-

larly qualified person in order to avoid a hazard.

1 2 3 4 5 6 7 8 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Merlin Powerlift Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Garagentor-Öffner Merlin Powerlift